CYD-Klipper
An implementation of a Klipper status display on an ESP32 + screen.
Uses Moonraker to fetch data.
Source code is available on GitHub.
Changelog
Donate
If you found this project helpful, please consider a donation to my Ko-Fi.
It would help out a lot in the development of this project, due to the need to buy the screens.
Thank you!
Report Issues
If you experience any issues with this project, or have any feature requests for the project, please report them on the issues tab on Github.
Install
Select your device from the list below and click 'Connect'.
Note: You may need to hold the 'BOOT' button on the device while pressing install.
The 2.8" Resistive and 3.5" Capacitive models are best suited (in my opinion) for CYD-Klipper.
Note for any resistive models: You can clear touch calibration by holding the BOOT button for 8 seconds while the screen is on.
Config
After installing CYD-Klipper, you can configure it using its touchscreen, or serial console. To use the serial console,
click 'Connect', select the serial port, select "LOGS & CONSOLE" and reset the board without holding BOOT.
Type help for list of available commands. You're interested in ssid, ip and key. (while you can set touch, it's really better done using the touchscreen.)